Birth record · free chart
Cross stitch birth announcement
A name, a date, a weight, a length — set on the grid in one piece, with a border and an ornament if you want them. The chart and the shopping list come out together.
Free · No account · Built in your browser · Nothing uploaded
Classic and Keepsake keep lowercase. Modern charts it in capitals.
Serif name, small capitals underneath, a double rule around the piece.
- Finished size
- 7.4" × 3.4"
- Fabric to cut
- 11.5" × 7.5"
- Floss
- 1 skein
- Stitching time
- 11 hrs
Elizabeth Rose — birth record
Charted with StitchText. Floss figures are estimates.
What actually goes on a birth sampler
Four lines, almost always in this order, and almost always at three different sizes. Getting the sizes wrong is what makes a finished piece look homemade in the wrong way.
The name, largest
Big enough to carry the piece. Serif keeps lowercase, which is what most names want; Slab charts in capitals and reads harder from a distance. Either way the name sets the width of everything below it.
The date, second
A full month name is warmer than 18.11.26 and costs about twenty stitches more. Keep it clearly smaller than the name — the eye should land on the name first, always.
Weight and length, smallest
These are detail, not headline. Set them in the smallest face that still resolves at your fabric count. On 14 count that is a three-by-five alphabet; on 18 count, think twice.
Before you cut the fabric
The stitched area is never the piece you buy. This is the mistake that ruins more first samplers than any other.
A 14 count birth record with a name across the top and three lines under it usually lands somewhere around seven by nine inches of stitching. Add two inches of margin on every side and you are cutting eleven by thirteen — not nine by eleven. The margin doubles, because it is on both sides.
Two inches is enough to lace over a mounting board. Three is safer if the piece will be framed by someone else, since framers trim. One inch is fine for a card that gets cut down afterwards.
One colour, or three
Most birth records are worked in a single thread colour on white or antique white Aida. A second colour is usually reserved for the ornament or the border, and a third for the date — enough separation to guide the eye without turning the piece into a colour chart.
Whatever you choose, buy all of one colour at once. Dye lots shift, and a mid-piece change shows up in daylight even when it looks identical under a lamp.
If the piece has to fit a frame you already own
Measure the opening, subtract half an inch on each side for the mount, then divide by your fabric count to get the stitch budget. On 14 count, a 7 × 9 inch opening gives you roughly 84 by 112 stitches to work inside. If the name does not fit that width, the layout has to change — a shorter face, a two-line name, or a smaller count — and it is much cheaper to discover that here than after the first hundred stitches.
Questions before the first stitch
The ones that come up most often on a birth record.
What size is a birth record normally stitched at?
Most are made to fit an 8 × 10 inch frame, which on 14 count is a usable area of about 112 by 140 stitches. That is enough for a name across the top, three or four lines underneath, and a border with air around it. If you already own the frame, measure the opening first and work backwards — the chart here shows the finished size before you cut anything.
Which fabric count should I choose?
Fourteen count, unless the piece has to be smaller. At 14 count the name stays large enough to read from a step away, and the small lines underneath still resolve. Moving to 18 count shrinks the whole piece by about a fifth, which is useful for a smaller frame but starts closing up the counters in letters like e and a.
Can I add the time of birth, or the parents’ names?
This page covers the four lines that almost every birth sampler carries: name, date, weight and length. For anything longer — time, parents, siblings, a short verse — use the main generator, where you can type as many lines as you like and set the font for each one yourself.
Is the chart really free, and can I sell what I stitch?
Free, no account, no watermark. The chart is drawn in your browser, so the name you type is not sent anywhere. Stitch it, frame it, give it away, or sell the finished piece. The only thing to leave alone is reselling the chart file itself.
Why does the ornament look blocky?
Because it is drawn on the same grid as the letters. A heart eight stitches tall has no room for a curve, so it is built from a staircase — the same compromise every counted motif makes. At 14 count it reads as a heart from normal viewing distance; zoomed in on screen it will always look like squares.
Keep going
Everything else on the site that this page leans on.
The full generator
Any wording, any number of lines, every font, wrap and spacing control.
The fonts
Every face drawn on the grid, with the letters that usually break shown side by side.
The fabric calculator
Already have a stitch count? Work out the cut size on its own, across every count.